![]() ![]() In the example above, you can see the PID using port 104 and the corresponding process was javaw.exe. The LMC allows you to restart the License Manager service, view status, view usage, view your installed license file and much more. It is installed with the Ansys License Manager software. Once the offending process has been found, you will need to either stop and disable that service or change the port to something other than 1084 and restart the Ansys License Manager installation. The Ansys License Management Center (LMC) (60 sec Overview) The LMC is a webpage where you install and manage your your Ansys License. ![]() Next, take that PID and replace the xxxxx with the discovered PID in the following command. The license file has been edited and accidentally corrupted. For more information on starting a license server, see the section 'Starting the license server' in the Arm License Management Guide. Run 'lmutil lmstat -a' on the server to check that the server software is running. This should return a line with a Process ID (PID) at the end. The license server software has not been started. To determine what is using port 1084, open a command prompt, type the following then hit enter: This is due to another running program or service that is already using port 1084. ![]() *This example was taken from this version, but is not necessary limited to this version. The licensingĬonfiguration cannot continue until this issue is resolved. The Tomcat server cannot be started until this port is free. When installing the Ansys License Manager you receive the following error:įATAL ERROR: Port 1084 is in use. ERROR - "FATAL ERROR: Port 1084 is in use." when installing Ansys License ManagerĪuthored by Matthew Trachimowicz February 4th, 2022 169 views 0 likes KB1231105 ERROR
0 Comments
Leave a Reply. |